These photos are showing when you go over an existing floor and your not sure if the new floor will hold to the existing floor, you need to test the area, in this case our first test failed we used a normal vct trowel notch and the glue didn’t have enough bite, so we used a bigger notched trowel and waited for the glue to completely set clear and it grabbed very well, couldn’t pull it off the rubber.the rubber ended up being a good floor to go over. In a couple of the pictures below show skim coating, and the skim coating needs to be done in order to prevent irregularities before the new floor is installed. This job was done in Telford, PA located in Bucks & Montgomery Counties.
.jpg)
